Symtech HBA 5 With Line Laser User Manual

ELECTRONIC HEADLAMP ALIGNMENT SYSTEM ASSEMBLY CALIBRATION OPERATION REV 4/30

10NOTE: When positioning the alignment head take caution not to rotate the alignment head out of position as determined by the line laser . 3.5 HEA

112. Measure height of laser beam at both front and rear wheels using a tape measure. 3. Adjust rear eccentric wheel so that the height of the la

12NOTE: FLOOR SLOPE LASER IS CALIBRATED AT FACTORY, CALIBRATION IS REQUIRED ONLY IN THE EVENT OF TAMPERING WITH ADJUSTMENT SCREW OR ASSURANCE OF LA

13• Switch lamp to LOW BEAM mode and visually observe placement of low beam on rear alignment screen of HBA 5. Pattern should be in a relative pos

14 All Symtech Corporation products are warranted to be free from defects in material and workmanship under normal u

2

3INDEX 1. GENERAL Pg. 5 1.1 GENERAL ASSEMBLY INSTRUCTIONS 1.2 BASE / MAST CALIBRATION 1.3 LINE LASER CALIBRATION PROCEDURE 2. SYSTEM COMPONE

4

51.1 GENERAL ASSEMBLY INSTRUCTIONS Step 1 Install Front Eccentric Axle assembly (eccentric without scale) into front of wheel base .

62.0 SYSTEM COMPONENTS 2.1 CONTROL PANEL The CONTROL PANEL consists of FIVE areas of interest. 1. ADJUST SELECTION MODE BUT

73 When auditing the headlamp, the arrows indicate if the lamp is within or out of allowable limits of +/- 4 inches. 2.1.5 BATTERY CHARGER SOCKE

8 2.4.3 WHEELS TO WHEELBASE MOUNTING There are three wheels on the wheelbase. Two wheels have an axle block that allows them to fit inside the wheel

94. Install laser on top of alignment head placing position pin in hole located in center of bezel 5. Turn on the laser. 6. Move to the front whe